Wireless Range Extender Amplifier 2.4 GHz
This is the most impressive and easiest way to extend the range of your wireless router, access point or repeater. If your wireless connection is falling out in your home or you have disconnect problems, purchase this solution and it will never happen again.
This 1/2 watt amplifier works at B, G or Super G speeds and includes a transmit and receive amplifier with amazing specifications.
This amplifier will work with virtually any type router including Linksys, Motorola, D-link, Linksys, etc, basically all of the wireless access points which require either an RP-SMA or an RP-TNC type connector. For a detail on the connector type for most routers, please refer to our cable page.
Amplifiers cannot be used with RadioLabs Long Range Notebook Cards High Power, Access Points, or any wireless device generating more than 100mW output.
Specification
| Model #WRE500MW | - Wireless Range Extender - |
| Amplifier Specifications | |
| Frequency Band | 2.4 ~ 2.5 GHz |
| 802.11 specifications | 802.11B, G and Super G compatible |
| Signal Type | DSSS - Multimode |
| Receiver Specifications | |
| RX Max. Input Power | -10 dBm |
RX Power Gain | 20 dB |
| Transmitter Specifications | |
| TX Input Power | 0 ~ +20 dBm |
| TX Power Gain | 13 dB |
| TX Linear output Power | 500 mW / +27 dBm |
| TX/RX Switch Time | <> |
| User Interface | |
Diagnosis LED | Power = Green |
| Power Requirements | |
| DC Supply Voltage | 6.5 VDC thru included adapter |
| Current Consumption | 550 mA maximum during TX |
| Mechanical Specifications | |
| RF Connector Type | RP-SMA or RP-TNC type |
| Operating Temperature | 0 °C ~ +40 °C Guaranteed specs. |
Features:
*
Bi-directional amplifier for IEEE 802.11B, G and Super G
*
Automatic gain control to minimize the signal distortion on all access points
* High Power transmit level, 500mW (or +27dBm)
*
Low noise amplifier with system noise figure 2.5dB
*
110 volt - 6.5VDC power adapter for operation from wall current.
*
Industry standard RP-SMA or RP-TNC type connector options.
*
Sturdy aluminum chassis with integrated heat-sink
* Power, Receive and transmit diagnostic lights.
source :radiolabs.com